April to October 2005

A lot has been done in this time including gaining out first MOT!  Loads of pics of welding and more bits of metal being stuck to the car and finally some mechanical work on getting the rear brakes sorted out.  The car sailed through it's MOT with no problems at all, but then a week later we discovered that a couple of the valve springs were broken, so I had to do some un-scheduled work on the old A series engine so we had a car to drive for a bit...

We have also made sub frames for the new seats and put some carpet in.

	New A panel in place.		Displaying our club.		First fit of the bootlid after putitng the new rear panel on		Getting the head gasket ready to bolt down		Part of our new interior
	The A series with the head off		The A series with the head on		The head with all new valve springs		Rear drums on and ready to go		our new seats in place
	Another shot of the back		On it's rear wheels for the first time in a while!		The inside of the rear brakes		The new rear sub frame in position		Our interior again
	Frank sorting out our timing		Me doing some welding		A nice patch at the edge of the wing